Each year, we manufacture hundreds of millions of studs in our own factory, and all of those studs
must pass our quality control process involving careful and extremely
rigorous measurements. However, before ending up on the production line, our studs have already been through an extensive design,
product development, and testing process. The process of developing a design idea
into a finished product attached to a tyre usually takes anything from two to three years.
When we are developing stud solutions for tyre manufacturers, our goal is to always make our customers’ work as easy as possible. We follow the established timetables, perform the wide range of testing necessary and take care of type approvals. We know the laws and regulations of different countries, and we have direct connections to the relevant authorities.
We guarantee full confidentiality to our customers and make sure their intellectual property rights are protected. We take our customers’ information security and the protection of their business ideas very seriously.
We enjoy facing and overcoming challenges, and we tackle all development projects with enthusiastic expertise. We collaborate with testing and research facilities and institutions granting type approvals – and we offer you all these services through a single partner.
We are involved in every step of the process to guarantee
the best possible results for our customers. We will listen to you and propose solutions
aimed at creating the best product possible.
We want to offer our customers the best possible grip with reduced road wear. Our goal is to make Scason studs as environmentally friendly as possible. To this end, we carry out stud tests throughout the year. We may drive up to 40,000 kilometres per tyre during winter wear tests. On snowy, icy, and wet roads, we can test the entire lifespan of the stud and tyre in just a few months.